How to replace Honda ECM PCM with VXDIAG Honda HDS


When the ECM/PCM is replaced, it is necessary to be recognized a code each other to the ECM/PCM and the Immobilizer Control Unit-Receiver with the VXDIAG Honda HDS. Also, the vehicle with Keyless Access System needs to be recognized a code each other to the ECM/PCM and Keyless Access Control Unit. Otherwise, the engine cannot be started.

 

1.System Selection Menu, click [IMMOBI]

replace-honda-pcm-vxdiag-hds-1

2.Click [Replace ECM/PCM]

replace-honda-pcm-vxdiag-hds-2

replace-honda-pcm-vxdiag-hds-3

3.Press tick to continue

Obtain PCM-code from MaRIS2/GENPO/Distributor

replace-honda-pcm-vxdiag-hds-4

4.Input PCM-code and Press tick to continue

PCM-code to use [Acura code Generator] calculated, you can buy it from ALLSCANNER Tech Co.,Ltd. Tel:0755-33000960

replace-honda-pcm-vxdiag-hds-5

5.Turn the ignition switch off

replace-honda-pcm-vxdiag-hds-6

6.Turn the ignition switch on

replace-honda-pcm-vxdiag-hds-7

7.Turn the ignition switch off.

The registration of immobilizer codes into the Immobilizer unit has been completed.

replace-honda-pcm-vxdiag-hds-8

8.Press tick to continue

Check all keys to ensure each will start the engine

replace-honda-pcm-vxdiag-hds-9

9.Click [NO]

Is this vehicle equipped with a KEYLESS ACCESS Remote System?

replace-honda-pcm-vxdiag-hds-10

10.The registration is complete.Press tick to continue

replace-honda-pcm-vxdiag-hds-11

Done.