Buick 2008 GL8 SPS Programming with Vxdiag VCX NANO J2534

---

How-to: perform Buick 2008 Passenger car GL8 online Service Programming System (SPS)  using vxdiag vcx nano for gm/opel j2534 interface.   SPS subscription from ACDelco TDS website is required.

 

 

Car info:

Buick 2008

Passenger car

GL8 Firstland

(C) 3.0L V6 LZC

 

Controller:

ECM: Engine Control Module &nD-A-Sh; Programming (Pass -Thru Only)

TCM: Transmission Control Module

PSDM: Power Sliding Door Module &nD-A-Sh; Programming

CCP: Climate Control Panel &nD-A-Sh; programming

 

Purpose: Reprogram (Normal not VCI)

 

Using:

J2534 Vxdiag Interface

Login ACDelco for subscription of Service Programming System (SPS)

Procedure:

Login ACDelco TDS.

Click on “Service and Programming Information”.

Choose ” Service Programming Only” and click on “Access your subscription”.

 

Click on “OK”.

 

Click on “Service Programming System (SPS)”.

 

Click on “Start SPS” and it will automatically launch Java 6.

 

Skip software installation of Tech2 J2534 Driver.

 

Select “J2534 VXDIAG” &nD-A-Sh; “Reprogram ECU“, then “Next“.

 

Read messages “Connect J2534 device to vehicle and PC”.

 

Select Buick car info.

Confirm car VIN.

Select ” ECM: Engine Control Module &nD-A-Sh; Programming (Pass -Thru Only)”, then “Normal”.

Configuration succeed.

Click on “Next” and then “OK” to reprogram with the same calibration.

 

Transfer data.

1). Download from server

2). Load to ECU.

It may take a long time to finish, please ensure the computer not sleep.

3). Programming complete.

Click on “New”, then “Next”, select ” TCM: Transmission Control Module”, then “Normal”.

Read the reprogramming instruction.

 

Download from the server completed.

Reprogramming completed with J2534 Vxdiag.

Done.